Outline

I/O

Inputs

TOTAL 10ch : Mono (MIC/LINE):4, Stereo(LINE):3

Phantom power

CH1, 2 : +30 V

Outputs

SPEAKERS [L, R], MONITOR OUT [L,R], SUBWOOFER OUT

Control and others

FOOT SW : Effect Mute on/off

Bus

Stereo: 1, Effect: 1

Input Channel Function

PAD

26 dB (CH1-4)

Hi-Z

Supported (CH4)

EQ HIGH

8kHz +15dB / -15dB

EQ MID

2.5kHz +15dB / -15dB

EQ LOW

100Hz +15dB / -15dB

On-board processors

DSP

SPX Algorithm Reverb 4 programs, MASTER EQ (SPEECH to MUSIC), Feedback suppressor

On-board amplifiers

Maximum output power @4ohms

1kHz THD+N less than 10% (CEA2006) : 250 W + 250 W, 1kHz THD+N less than 1% : 110 W + 110 W

Maximum output power @8ohms

1kHz THD+N less than 10% (CEA2006) : 170 W + 170 W, 1kHz THD+N less than 1% : 110 W + 110 W

Level Meter

6points (-20, -6, 0 , +3, +6, LIMITER)

General specifications

Frequency response

Input to SPEAKERS : +1 dB/-4 dB (40Hz to 20kHz), Input to MONITOR OUT : +0.5 dB/-1.5 dB (20Hz to 20kHz) , refer to the nominal output level @ 1 kHz

Total harmonic distortion

Input to SPEAKERS : 0.2 % @ 13.8 W (40Hz to 20kHz), 0.4 % @ 23.2W (1kHz), Input to MONITOR OUT : 0.05 % @ +10 dBu (20Hz to 20kHz) 0.009 % @ +20 dBu (1kHz), (THD+N, Measured with 22 kHz LPF)

Hum & noise level

Equivalent input noise

-115 dBu

Residual output noise

Input to SPEAKERS : -68 dBu (40Hz to 20kHz, MASTER: min), Input to MONITOR OUT : -99 dBu (20Hz to 20kHz, MONITOR: min)

Crosstalk

-80 dB (1 kHz, Measured with 1 kHz band pass filter)

Protection circuit

Load protection

DC-fault

Amplifier protection